Administrator Guide

Example
Dell#conf
Dell(conf)#interface vlan 2
Dell(conf-if-vl-2)#vlan-stack compatible
Dell(conf-if-vl-2)#member Te 1/2-3
Dell(conf-if-vl-2)#protocol-tunnel stp
Dell(conf-if-vl-2)#protocol-tunnel enable
Related Command show protocol-tunnel — displays tunneling information for all VLANs.
protocol-tunnel destination-mac
Overwrite the BPDU destination MAC address with a specific value.
C9000 Series
Syntax
protocol-tunnel destination-mac xstp address
Parameters
stp Change the default destination MAC address used for L2PT to another value.
Defaults The default destination MAC is 01:01:e8:00:00:00.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series, and S-Series.
7.4.1.0 Introduced
Usage Information When you enable VLAN-Stacking, no protocol packets are tunneled.
Related Command show protocol-tunnel — displays tunneling information for all VLANs.
protocol-tunnel enable
Enable protocol tunneling globally on the system.
C9000 Series
Syntax
protocol-tunnel enable
To disable protocol tunneling, use the no protocol-tunnel enable command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Service Provider Bridging 1469