Administrator Guide

Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.2 Added support for the access parameter.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information The following Example specifies the group named harig as a version 3 user requiring both authentication and
encryption and read access limited to the read named rview.
NOTE: The number of configurable groups is limited to 16 groups.
Example
Dell#conf
Dell(conf)# snmp-server group harig 3 priv read rview
Dell#
Related
Commands
show snmp group — displays the group name, security model, view status, and storage type of each group.
show running-config — displays the SNMP running configuration.
snmp-server host
Configure the recipient of an SNMP trap operation.
C9000 Series
Syntax
snmp-server host ip-address | ipv6-address | hostname [vrf management traps |
informs] [version 1 | 2c | 3] [auth | no auth | priv] [community-string] [udp-
port port-number] [notification-type]
To remove the SNMP host, use the no snmp-server host ip-address | ipv6-address | hostname [vrf management
traps | informs] [version 1 | 2c | 3] [auth | noauth | priv] [community-string] [udp-port number] [notification-type]
command.
Parameters
ip-address Enter the keyword host followed by the IP address of the host (Configurable hosts are
limited to 16).
ipv6-address Enter the keyword host then the IPv6 address of the host in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zero.
hostname Enter the keyword host followed by the name of a host already configured and
recognized by the switch.
vrf management Enter the keyword vrf followed by the keyword management to specify that
management vrf will be used to send traps and informs.
traps (OPTIONAL) Enter the keyword traps to send trap notifications to the specified host.
The default is traps.
informs (OPTIONAL) Enter the keyword informs to send inform notifications to the specified
host. The default is traps.
version 1 | 2c | 3 (OPTIONAL) Enter the keyword version to specify the security model then the security
model version number 1, 2c, or 3:
• Version 1 is the least secure version.
• Version 3 is the most secure of the security modes.
Simple Network Management Protocol (SNMP) and Syslog 1495