Administrator Guide
Defaults None.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
Usage Information
Trace log information is uploaded to flash:/TRACE_LOG_DIR
In a dual homing setup, you can use this command only from the primary VLT peer.
util-threshold cpu
Configure the high or low CPU utilization thresholds for SNMP traps.
C9000 Series
Syntax
util—threshold cpu {5sec | 1min | 5min} {all | cp |lp slot–id | pe | rp} {high
{0-100} | low {0-100}}
Parameters
cpu-utilization-
time
Enter one of the following values to configure the threshold level for the time in which a
switch CPU can be used:
• 5 sec
• 1 min
• 5 min
cp Enter the keyword cp to configure the CPU utilization time for the Control Processor
CPU.
rp Enter the keyword rp to configure the CPU utilization time for the Route Processor CPU.
lp
slot-id
Enter the keyword lp and the linecard processor (lp) slot-id for which you want to
configure the CPU utilization time. The range for lp slot-id is from 0 to 11.
pe Enter the keywordpe to configure the CPU utilization time for port extenders (PE)
configured in the system. Range is from 0 to 255.
NOTE: The pe option is only available when the extended bridge feature is
enabled.
all Enter the keyword all to configure the CPU utilization time on all switch CPUs: Control
Processor, Route Processor, port extender (PE) and line cards.
{{high | low}
cpu-
utilization-
threshold-
percentage
}
Enter a percentage value to configure the high or low threshold level for the time in which
a switch CPU can be used. The percentage of CPU use ranges from 0 to 100.
NOTE: A threshold level of 0 disables Syslog and SNMP traps.
Defaults
• High CPU utilization threshold: 1 min = 85%, 5 min = 80%
• Low CPU utilization threshold: 1 min = 75%, 5 min = 70%
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
152 Control and Monitoring