Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

151

152

153

154

155

156

157

158

159

160

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

9.0.0.0 Introduced on the Z9000

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series ExaScale.

7.5.1.0 Introduced on the C-Series.

E-Series Original command.

Usage Information

You can configure both IPv4 and IPv6 virtual addresses simultaneously, but only one of each. Each time this

command is issued, it replaces the previously configured address of the same family, IPv4 or IPv6. The no

virtual-ip command takes an address/prefix-length argument, so that the desired address only is removed. If

you enter the no virtual-ip command without any specified address, then both IPv4 and IPv6 virtual

addresses are removed.

Commands

ip address — assigns a primary and secondary IP address to the interface.

write

Copy the current configuration to either the startup-configuration file or the terminal.

C9000 Series

Syntax

write {memory | terminal}

Parameters

memory Enter the keyword memory to copy the current running configuration to the startup

configuration file. This command is similar to the copy running-config startup-

config command.

terminal Enter the keyword terminal to copy the current running configuration to the terminal.

This command is similar to the show running-config command.

Command Modes EXEC Privilege