Administrator Guide

storm-control unknown-unicast (Interface)
Configure percentage of unknown-unicast traffic allowed on an interface (ingress only).
C9000 Series
Syntax
storm-control unknown-unicast [percentage decimal_value in] | [wred-profile
name]] [packets_per_second in]
To disable unknown-unicast storm control on the interface, use the no storm-control unknown-unicast
[percentage decimal_value in] | [wred-profile name]] [packets_per_second in]
command.
Parameters
percentage
decimal_value [in |
out]
E-Series Only: Enter the percentage of broadcast traffic allowed in or out of the network.
Optionally, you can designate a decimal value percentage, for example, 55.5%.
The percentage is from 0 to 100:
• 0% blocks all related traffic.
• 100% allows all traffic into the interface.
The decimal range is from 0.1 to 0.9.
wred-profile name E-Series Only: (Optionally) Enter the keywords wred-profile followed by the profile
name to designate a wred-profile.
packets_per_seco
nd in
C-Series and S-Series Only: Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554431.
Defaults none
Command Modes INTERFACE (conf-if-interface-slot/port)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 E-Series Only: Added the percentage decimal value option.
6.5.1.0 Introduced on the E-Series.
Storm Control 1551