Administrator Guide
System Time and Date
The commands in this chapter configure time values on the system, either using the Dell Networking operating software, or the hardware,
or using the network time protocol (NTP). With NTP, the switch can act only as a client to an NTP clock host.
For more information, refer to the “Network Time Protocol” section of the Management chapter in the Dell Networking OS Configuration
Guide.
Topics:
• clock set
• clock summer-time date
• clock summer-time recurring
• clock timezone
• debug ntp
• ntp authenticate
• ntp authentication-key
• ntp broadcast client
• ntp disable
• ntp master <stratum>
• ntp multicast client
• ntp offset-threshold
• ntp server
• ntp source
• ntp trusted-key
• show clock
• show ntp associations
• show ntp status
• show ntp vrf associations
clock set
Set the software clock in the switch.
C9000 Series
Syntax
clock set time month day year
Parameters
time
Enter the time in hours:minutes:seconds. For the hour variable, use the 24-hour format;
example, 17:15:00 is 5:15 pm.
month
Enter the name of one of the 12 months, in English. You can enter the number of a day
and change the order of the display to time day month year.
day
Enter the number of the day. The range is from 1 to 31. You can enter the name of a
month to change the order of the display to time month day year.
year
Enter a four-digit number as the year. The range is from 1993 to 2035.
Defaults Not configured.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
60
1570 System Time and Date