Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1601

multicast peer-routing timeout

Configure the time for a VLT node to retain synced multicast routes or synced multicast outgoing interface (OIF) after a VLT peer node

failure.

C9000 Series

Syntax

multicast peer-routing timeout value

To restore the default value, use the no multicast peer-routing timeout command.

Parameters

value

Enter the timeout value in seconds. The range is from 1 to 1200. The default is 150.

Command Modes VLT DOMAIN (conf-vlt-domain)

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.5(0.1 Introduced on the Z9500.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux

(PMUX) mode only.

9.2(0.2) Introduced on the Z9000, S4810, and S4820T.

9.0.2.0 Introduced on the S6000.

peer-link port-channel

Configure the specified port channel as the chassis interconnect trunk between VLT peers in the domain.

C9000 Series

Syntax

peer-link port-channel port-channel-number {peer-down-vlan vlan id}

Parameters

port-channel-

number

Enter the port-channel number that acts as the interconnect trunk.

peer-down-vlan

vlan id

Enter the keyword peer-down-vlan then a VLAN ID to configure the VLAN that the

VLT peer link uses when the VLT peer is down.

Defaults Not configured.

Command Modes VLT DOMAIN