Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1611

vlt domain

Enable VLT on a switch, configure a VLT domain, and enter VLT-domain configuration mode.

C9000 Series

Syntax

vlt domain domain-id

Parameters

domain-id

Enter the Domain ID number. Configure the same domain ID on the peer switch. The

range of domain IDs is from 1 to 1000.

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.5(0.1) Introduced on the Z9500.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux

(PMUX) mode only.

9.0.2.0 Introduced on the S6000.

9.0.0.0 Introduced on the Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.8.0 Introduced on the S4810.

Usage Information The VLT domain ID must be the same between the two VLT devices. If the domain ID is not the same, a syslog

message is generated and VLT does not launch.

Commands

show vlt — uses the show vlt brief command to display the delay-restore value.

vlt-peer-lag port-channel

Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to an attached device.

C9000 Series

Syntax

vlt-peer-lag port-channel id-number

Parameters

id-number

Enter the respective vlt port-channel number of the peer device.

Defaults Not configured.

Command Modes INTERFACE PORT-CHANNEL