Administrator Guide
Version Description
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage Information You can use the version both command to migrate from VRRPv2 to VRRPv3. When you set the VRRP protocol
version to both, the switch sends only VRRPv3 advertisements but can receive either VRRPv2 or VRRPv3
packets. To migrate an IPv4 VRRP group from VRRPv2 to VRRPv3:
1. Set the switches with the lowest priority to “both”.
2. Set the switch with the highest priority to version to 3.
3. Set all the switches from both to version 3.
NOTE: Do not run VRRP version 2 and version 3 in the same group for an extended period of time.
Example
Dell(conf-if-te-0/0-vrid-100)#version ?
2 VRRPv2
3 VRRPv3
both Interoperable, send VRRPv3 receive
both
Dell(conf-if-te-0/0-vrid-100)#version 3
virtual-address
Configure up to 12 IP addresses of virtual routers in the VRRP group. To start sending VRRP packets, set at least one virtual address for
the VRRP group.
C9000 Series
Syntax
virtual-address ip-address1 [... ip-address12]
To delete one or more virtual IP addresses, use the no virtual-address ip-address1 [... ip-
address12] command.
Parameters
ip-address1
Enter an IP address of the virtual router in dotted decimal format. The IP address must be
on the same subnet as the interface’s primary IP address.
... ip-address12
(OPTIONAL) Enter up to 11 additional IP addresses of virtual routers in dotted decimal
format. Separate the IP addresses with a space. The IP addresses must be on the same
subnet as the interface’s primary IP address.
Defaults Not configured.
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
1636 Virtual Router Redundancy Protocol (VRRP)