Administrator Guide

Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to version 7.8.1.0, names
are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for the non-contiguous mask and added the monitor option.
6.5.1.0 Expanded to include the optional QoS order priority for the ACL entry.
Usage Information
The system supports one ingress and one egress IP ACL per interface.
The number of entries allowed per ACL is hardware-dependent. For detailed information on the number entries
allowed per ACL on the C9000, refer to the Content Addressable Memory (CAM) chapter in the C9000
Configuration Guide.
Use this command in Configuration Terminal Batch mode to create a standard IP access list in a dual-homing
setup.
Example
Dell(conf)#ip access-list standard TestList
Dell(config-std-nacl)#
Related
Commands
ip access-list extended — creates an extended access list.
show config — displays the current configuration.
permit
Configure a filter to permit packets from a specific source IP address to be processed and forwarded to another interface on the switch.
C9000 Series
Syntax
permit {source [mask]| any | host ip-address}[count [byte]] [dscp value]
[order] [fragments] [log [interval minutes] [threshold-in-msgs [count]]
[monitor]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s sequence number.
• Use the no permit {source [mask] | any | host ip-address} command.
Parameters
source Enter the IP address in dotted decimal format of the network from which the packet was
sent.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when
specified in A.B.C.D format, may be either contiguous or non-contiguous.
216 Access Control Lists (ACL)