Administrator Guide

Usage Information
Use the order option only when you use policy-based QoS on the switch. For more information, refer to the
Quality of Service chapter of the C9000 Series Configuration Guide. The following conditions apply:
• The seq sequence-number command is applicable only in an ACL group.
• The order option works across ACL groups that have been applied on an interface via the QoS policy
framework.
• The order option takes precedence over seq sequence-number.
• If sequence-number is not configured, the rules with the same order value are ordered according to their
configuration order.
• If sequence-number is configured, the sequence-number is used as a tie breaker for rules with the same
order.
When you use the log option, the CP processor logs detail the packets that match. Depending on how many
packets match the log entry and at what rate, the CP may become busy as it has to log these packets’ details.
By default, 10 ACL logs are generated if you do not specify the threshold explicitly. The default frequency at which
ACL logs are generated is five minutes. By default, flow-based monitoring is not enabled.
Use the monitor option only when you are using flow-based monitoring. For more information, refer to the Port
Monitoring chapter of the C9000 Series Configuration Guide.
Related
Commands
deny — configures a filter to drop packets.
permit — configures a filter to forward packets.
show ip access-lists
Display inbound or outbound IP access-list information based on a given option.
C9000 Series
Syntax
show ip access-lists {interface interface [in | out]}
Parameters
interface Enter the keyword interface then one of the following keywords and slot/port or pe-
id / stack-unit / port-id information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN interface, enter the keyword vlan then the slot/port number.
• For a Port Channel interface, enter the keyword port-channel then a port channel
number.
• For a port extender Gigabit Ethernet interface, enter the keyword peGigE then the
pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id range is from 1 to 48.
in Enter the keyword in to display information for an ip ingress or inbound access-list
attached to an interface.
out Enter the keyword out to display information for an ip egress or outbound access-list
attached to an interface.
Defaults None
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Access Control Lists (ACL) 221