Administrator Guide

Total Ports: 4001
Example
An ACL rule with a TCP port lt 1023 uses only one entry in the CAM.
Rule# Data Mask From To #Covered
1 0000000000000000 1111110000000000 0 1023 1024
Total Ports: 1024
Related
Commands
deny — assigns a filter to deny IP traffic.
deny udp — assigns a filter to deny UDP traffic.
deny udp
To drop user datagram protocol (UDP) packets meeting the filter criteria, configure a filter.
C9000 Series
Syntax
deny udp {source mask | any | host ip-address} [operator port [port]]
{destination mask | any | host ip-address} [dscp] [operator port [port]] [count
[bytes]] [log] [order] [monitor] [fragments]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s sequence number.
• Use the no deny udp {source mask | any | host ip-address} {destination mask |
any | host ip-address} command.
Parameters
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in
A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
dscp Enter this keyword dscp to deny a packet based on the DSCP value. The range is from 0
to 63.
operator (OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports for the port
command)
port port
Enter the application layer port number. Enter two port numbers if using the range logical
operand. The range is from 0 to 65535.
destination Enter the IP address of the network or host to which the packets are sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in
A.B.C.D format, may be either contiguous or non-contiguous.
count (OPTIONAL) Enter the keyword count to count packets processed by the filter.
bytes (OPTIONAL) Enter the keyword byte to count bytes processed by the filter.
log (OPTIONAL) Enter the keyword log to include ACL matches in the log.
Access Control Lists (ACL) 229