Administrator Guide

• Use the no seq sequence-number command if you know the filter’s sequence number.
• Use the no permit udp {source mask | any | host ip-address} {destination mask |
any | host ip-address command.
Parameters
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in
A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host and then enter the IP address to specify a host IP address.
dscp Enter the keyword dscp to deny a packet based on the DSCP value. The range is from 0
to 63.
operator (OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports for the port
parameter)
port port Enter the application layer port number. Enter two port numbers if you are using the
range logical operand. The range is 0 to 65535.
destination Enter the IP address of the network or host to which the packets are sent.
count (OPTIONAL) Enter the keyword count to count packets processed by the filter.
bytes (OPTIONAL) Enter the keyword bytes to count bytes processed by the filter.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry.
The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-
order numbers have a higher priority). If you do not use the keyword order, the ACLs
have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
log (OPTIONAL) Enter the keyword log to include ACL matches in the log.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny commands. The threshold
range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which ACL logs must be generated. The threshold range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you
want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface. For more information, refer to the “Flow-based Monitoring” section
in the Port Monitoring chapter of the Dell Networking OS Configuration Guide.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
238 Access Control Lists (ACL)