Administrator Guide

The MAC ACL supports an inverse mask; therefore, a mask of ff:ff:ff:ff:ff:ff allows entries
that do not match and a mask of 00:00:00:00:00:00 only allows entries that match
exactly.
mac-source-
address-mask
Specify which bits in the MAC address must be matched.
mac-destination-
address
Enter the destination MAC address and mask in nn:nn:nn:nn:nn:nn format.
mac-destination-
address-mask
Specify which bits in the MAC address must be matched.
The MAC ACL supports an inverse mask; therefore, a mask of ff:ff:ff:ff:ff:ff allows entries
that do not match and a mask of 00:00:00:00:00:00 only allows entries that match
exactly.
ethertype
operator
(OPTIONAL) To filter based on protocol type, enter one of the following Ethertypes:
• ev2 - is the Ethernet II frame format.
• llc - is the IEEE 802.3 frame format.
• snap - is the IEEE 802.3 SNAP frame format.
count (OPTIONAL) Enter the keyword count to count packets the filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the filter processes.
log (OPTIONAL) Enter the keyword log to include ACL messages in the log.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny commands. The threshold
range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which ACL logs must be generated. The threshold range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you
want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface. For more information, refer to the “Flow-based Monitoring” section
in the Port Monitoring chapter of the Dell Networking OS Configuration Guide.
Defaults Not configured.
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added the monitor option.
6.1.1.0 Introduced on the E-Series.
Usage Information
When you use the log option, the CP processor logs detail the packets that match. Depending on how many
packets match the log entry and at what rate, the CP may become busy as it has to log these packet details.
Access Control Lists (ACL) 263