Administrator Guide

Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to apply the distribute list filter to all routers in the peer
group.
prefix-list-name
Enter the name of an established prefix list.
If the prefix list is not configured, the default is permit (to allow all routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information Other BGP filtering commands include: neighbor filter-list, ip as-path access-list, and
neighbor route-map.
Related
Commands
ip as-path access-list — configures IP AS-Path ACL.
neighbor filter-list — assigns a AS-PATH list to a neighbor or peer group.
neighbor route-map — assigns a route map to a neighbor or peer group.
neighbor dmzlink-bw
Attach a Link Bandwidth to received routes.
C9000 Series
Syntax
neighbor {ip-address | peer-group} dmzlink-bw
To disable BGP Link Bandwidth, enter the no neighbor {ip-address | peer-group} dmzlink-bw
command.
Parameters
ip-address Enter the IP address of the peer.
peer-group Enter the name of the peer group.
dmzlink-bw Enter the keyword dmzlink-bw to enable BGP Link Bandwidth in BGP multipath.
Defaults N/A
Command Modes ROUTER BGP
Border Gateway Protocol 347