Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

361

362

363

364

365

366

367

368

369

370

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.3.1.0 Introduced the ability to substitute IGP cost for MED when a peer/peer-group outbound

route-map is set as internal.

7.8.1.0 Introduced on the S-Series.

7.7.1.0 Introduced on the C-Series.

Usage Information

You can use the redistribute command to advertise the IGP cost as the MED on redistributed routes. When

you set the route-map with metric-type internal and apply outbound to an EBGP peer/peer-group, the advertised

routes corresponding to those peer/peer-groups have the IGP cost set as MED.

When you enter the redistribute isis process-id command without any other parameters, the system

redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes. RFC does not support

this feature.

router bgp

To configure and enable BGP, enter ROUTER BGP mode.

C9000 Series

Syntax

router bgp as-number

To disable BGP, use the no router bgp as-number command.

Parameters

as-number

Enter the AS number. The range is from 1 to 65535 (2 byte), from 1 to 4294967295 (4

byte), or from 0.1 to 65535.65535 (dotted format).

Defaults Not enabled.

Command Modes CONFIGURATION