Administrator Guide

Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
Enter the CAM profile name and specify the amount of CAM space. The total space allocated must be equal to 13.
The range for ipv4acl is from 1 to 4. The ipv6acl range must be a factor of 2.
Related
Commands
show cam-acl-egress-pe
cam-acl-pe
Allocate content addressable memory (CAM) for the port extender.
C9000 Series
Syntax
cam-acl-pe [default| l2acl number ipv4acl number ipv6acl number ipv4qos number
l2qos number ipmacacl number]
Parameters
default Resets ACL CAM entries to default setting.
l2acl Allocates space for the L2 ACL. The default value is 5.
ipv4acl Allocates space for the L3 ACL. The default value is 2.
ipv6acl Allocates space for the IPv6 L3 ACL. The default value is 2.
ipv4qos Allocates space for the L3 QoS. The default value is 2.
l2qos Allocates space for L2 QoS. The default value is 1.
ipmacacl (Optional) Allocates space for IP and MAC ACLs. The default value is 0.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command-Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Guidelines
Select the CAM allocation for Layer 2, IPv4, and IPv6 ACLs, Layer 2 and Layer 3 (IPv4) QoS, Layer 2 Protocol
Tunneling (L2PT), IP and MAC source address validation for DHCP, and Policy-based Routing (PBR). Save the
new CAM settings to the startup-config (write-memor copy run start) then reload the system for the new
settings to take effect. The total amount of space allowed is 12 FP Blocks. System flow requires three blocks;
these blocks cannot be reallocated.
The ipv4acl profile range is from 1 to 4. When configuring space foripv6acl, the total number of Blocks must
equal 13. Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0 to 10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10). If allocation values are not entered for the CAM regions,
the value is 0.
cam-optimization
Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
C9000 Series
Syntax
cam-optimization [qos]
Content Addressable Memory (CAM) 475