Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

501

502

503

504

505

506

507

508

509

510

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

Version

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.7(0.1) Introduced on the S3048-ON and S4048-ON .

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

By default, iSCSI is enabled on the unit and the flow control is enabled on all of the interfaces. It is also acts as

defaults when the link-level flow control is enabled on one or more interfaces.

To enable DCB, do one of the following:

• Apply the dcb-input policy command with the no pfc-mode command on to all the interfaces.

• Disable flow-control on all of the interfaces.

Enables priority flow control or enhance transmission selection on interface.

Commands

dcb <ets | pfc> enable — enable priority flow control or enhanced transmission selection on interface.

dcb-output

To associate an ETS configuration with priority traffic, create a DCB output policy.

C9000 Series

Syntax

dcb-output policy-name

To remove the ETS output policy globally, use the no dcb output policy-name command.

Parameters

policy-name

Enter the DCB output policy name. The maximum is 32 alphanumeric characters.

Defaults none

Command Modes CONFIGURATION