Manualshelf

Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch
51525354555657585960
UPLINK STATE GROUP Mode
To enable and configure an uplink-state group, use UPLINK STATE GROUP mode. For more information, see Uplink Failure Detection
(UFD).
To enter UPLINK STATE GROUP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the uplink-state-group command then the group ID number. The prompt changes to include (conf-uplink-state-group-
groupID).
56 CLI Basics