Administrator Guide

Related
Commands
show running-config ecmp-group — displays interfaces, LAG, or LAG link bundles being monitored for uneven
traffic distribution.
show link-bundle distribution
Display the link-bundle distribution for the interfaces in the bundle, type of bundle (LAG or ECMP), and the most recently calculated
interface utilization (either bytes per second rate or maximum rate) for each interface.
C9000 Series
Syntax
show link-bundle-distribution
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information
In a dual homing setup, you can use this command only from the primary VLT peer.
Example
Dell# show link-bundle-distribution
Link-bundle trigger threshold - 60
ECMP bundle - 5 Utilization[In Percent] - 0 Alarm State - Inactive
Interface Line Protocol Utilization[In Percent]
Te 0/4 Up 5
Te 0/3 Up 30
618 Equal Cost Multi-Path (ECMP)