Administrator Guide

• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a port extender Gigabit Ethernet interface, enter the keyword peGigE then the
pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id range is from 0 to 47.
Defaults Without an interface specified, the command clears all interface dampening counters.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell# clear dampening tengigabitethernet 1/2
Clear dampening counters on Te 1/2 [confirm] y
Dell#
Related
Commands
• show interfaces dampening — displays interface dampening information.
• dampening — configures dampening on an interface.
combo-port-type
You can pre-provision the medium of combo ports as copper or fiber.
Syntax
combo-port-type{copper | fiber}
Parameters
copper Enter the keyword copper to provision the combo port as a copper port.
fiber Enter the keyword fiber to provision the combo port as a fiber port.
Defaults None
Command Modes INTERFACE
672 Interfaces