Administrator Guide

group interface (Optional) Enter the keyword group to configure an interface group. You can create a
interface group by adding a comma or hyphen separate list of the following interface
types:
• fortyGigE for a 40–Gigabit Ethernet interface.
• gigabitethernet for a GigabitEthernet interface.
• peGigE for a PE Gigabit Ethernet interface.
• TengigabitEthernet for a 10-Gigabit Ethernet interface.
• vlan for a VLAN interface.
range (Optional) Enter the keyword range to configure an interface range.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are not assigned to an IP address or switchport. To
place an interface in Layer 2 mode, ensure that the interface’s configuration does not contain an IP address and
enter the switchport command.
You can create up to 64 tunnel interfaces. The tunnel is added as a logical interface with no default configuration.
To delete a tunnel interface, use the no interface tunnel tunnel-id command.
Example
Dell(conf)# int tengigabitethernet 0/0
Dell(conf-if-te-0/0)#exit
Dell(conf)#
Example peGigE
Dell#show interfaces peGigE 0/0/0
peGigE 0/0/1 is up, line protocol is up
Hardware is DellEth, address is a0:68:00:3f:92:bd
Current address is a0:68:00:3f:92:bd
Pluggable media not present
Interface index is 536870919
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :a068003f92bd
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex
Auto-mdix enabled, ARP type: ARPA, ARP Timeout 04:00:00
Interfaces 679