Administrator Guide

Parameters
seconds Enter the number of seconds for which to collect traffic data. The range is from 5 to 299
seconds.
NOTE: Because polling occurs every 15 seconds, the number of seconds
designated here round to the multiple of 15 seconds lower than the entered
value. For example, if 44 seconds is designated, it rounds to 30; 45 to 59
seconds rounds to 45. If you configure this value to be less than 5, then the
entire buffer is cleared; the show int stats command shows the rate
information to be 0 as the polling interval is less than 5.
Defaults 299 seconds
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11.0.0 Introduced on all Dell Networking OS platforms.
Usage Information
The output of the show interfaces command displays the configured rate interval, along with the collected
traffic data.
When rate-interval is not configured in the global configuration mode or interface mode, the default value of 299
seconds is applied.
When rate-interval is configured only in the global configuration mode and not in the interface mode, the global
rate-interval value is applied at the interface level also.
When rate-interval is configured at the interface level and not in the global configuration mode, the interface level
rate-interval value is applied for an interface.
When rate interval is configured in both global configuration mode as well as interface mode, then the rate-
interval value configured at interface level is applied as it takes precedence over the global value.
show config
Display the interface configuration.
C9000 Series
Syntax
show config
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
696 Interfaces