Administrator Guide

no shutdown
Dell(conf-if-range-te-1/1-2)#
show interfaces
Display information on a specific physical or virtual interface, or the interfaces of the same type on a line card.
C9000 Series
Syntax
show interfaces [interface] [linecard slot-id]
From a PE console, use show interfaces to view the information on a specific physical or virtual interface.
Parameters
interface Enter one of the following keywords and slot/port or number information:
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is 1 to 4096.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel then the tunnel ID. The range is
from 1 to 16383.
• For a port extender Gigabit Ethernet interface, enter the keyword peGigE then the
pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id range is from 1 to 48.
NOTE: The peGigE option is only visible when the feature extended bridge
feature is enabled.
linecard slot-id Enter the linecard slot-id parameters to specify the switch ports on a line card.
The range of slot IDs is from 0 to 11.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.00 Introduced on the C9010 and C1048P.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Added support for the tunnel interface type.
9.1(0.0) Updated ManagementEthernet output to include two global IPv6 addresses on S4810 and
Z9000 and added output example showing OpenFlow instance ID.
8.3.12.1 Updated command output to support multiple IPv6 addresses on S4810.
8.3.11.4 Output expanded to support eSR4 optics in Z9000.
8.3.11.1 Introduced on the Z9000.
698 Interfaces