Administrator Guide

Related
Commands
interface port-channel — creates a port channel interface.
show interfaces switchport — displays information about switchport interfaces.
wavelength
Set the wavelength for tunable 10–Gigabit SFP+ optics.
Syntax
wavelength
To retain the existing wavelength, use the no wavelength command.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6000, S6000–ON, S5000, S4810, S4820T, S3048–ON, S4048–ON,
M I/O Aggregator, FN I/O Module, MXL, C9010, S3100 series, and Z9100-ON.
Usage Information
The wavelength can be configured only on a tunable 10–Gigabit SFP+ optic. The wavelength range is from 1528.3
nm to 1568.77nm.
If you configure the wavelength on a non-tunable optic, there is no change to the existing wavelength. The
configured wavelength is saved in the running configuration and is applicable, when a tunable optic is used.
If you do not configure the wavelength on an inserted tunable optic, the existing wavelength is used.
Example
The following example shows the wavelength set for a tunable 10–Gigabit SFP+ optic:
Related
Commands
show config — displays the interface configuration.
Egress Interface Selection (EIS) Commands
The following commands are Egress Interface Selection (EIS) commands.
application
Configure the management egress interface selection.
C9000 Series
Syntax
application {all | application-type}
To remove a management application configuration, use the no application {all | application-
type} command.
Parameters
application-type
Enter any of the following keywords:
For DNS, enter the keyword dns.
For FTP, enter the keyword ftp.
For NTP, enter the keyword ntp.
For Radius, enter the keyword radius.
For sFlow collectors, enter the keyword sflow-collector.
For SNMP (traps and MIB responses), enter the keywords snmp .
For SSH, enter the keyword ssh .
Interfaces 739