Administrator Guide

Rate info (interval 15 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Related
Commands
show hardware hg-stats — displays traffic statistics from internal ports in a HiGig link bundle.
hg-link-bundle-monitor enable
Enable the monitoring of link utilization and traffic distribution in backplane HiGig link bundles/port channels on a line-card or switch fabric
module (SFM) NPU.
C9000 Series
Syntax
hg-link-bundle-monitor {sfm npu-id hg-port—channel hg-port—channel-id | slot
slot npuUnit npu-id hg-port—channel 0} enable
To disable HiGig link-bundle monitoring, use the no version of this command.
Parameters
sfm npu-id hg-
port-channel hg-
port-channel-id
Specify a HiGig port channel on a switch SFM (spine) NPU by entering the keyword sfm
and SFM NPU ID, then hg-port-channel and a HiGig port channel ID. SFM NPU IDs
are 0 to 1; SFM HiGig port-channel IDs are 0 to 10.
slot slot-id
npuUnit npu-id
hg-port-channel 0
Specify a HiGig port channel on a line-card (leaf) NPU by entering the keyword slot and
slot number, then npuUnit and line-card NPU ID, then hg-port-channel 0. Line-
card slot numbers are 0 to 11; line-card NPU ID is 0 . The HiGig port-channel ID range is
from 0 to 2.
enable Enable HiGig link-bundle monitoring.
Command Mode CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.3.0.0 Introduced on the Z9000 switch.
Usage Information You can configure HiGig link bundle monitoring so that a system log message or an SNMP trap is generated when
traffic distribution in a bundle is uneven. The formula that determines uneven traffic distribution is predefined.
hg-link-bundle-monitor rate-interval
Specify the interval (in seconds) for polling traffic distribution in the member links of a HiGig link bundle.
C9000 Series
Syntax
hg-link-bundle-monitor rate-interval seconds
To restore the default value, use the no version of this command.
Parameters
seconds Polling interval in seconds. The valid values are from 10 to 299.
Command Mode CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500 switch.
754 Interfaces