Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

781

782

783

784

785

786

787

788

789

790

Parameters

multi-point (OPTIONAL) Enter the keywords multi-point to pad only LAN hello PDUs.

point-to-point (OPTIONAL) Enter the keywords point-to-point to pad only point-to-point PDUs.

Defaults Both LAN and point-to-point hello PDUs are padded.

Command Modes ROUTER ISIS

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.5(0.1) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.11.1 Introduced on the Z9000.

Usage Information IS-IS hellos are padded to the full maximum transmission unit (MTU) size. Padding IS-IS Hellos (IIHS) to the full

MTU provides early error detection of large frame transmission problems or mismatched MTUs on adjacent

interfaces.

Commands

isis hello padding — turns ON or OFF hello padding on an interface basis.

hostname dynamic

Enables dynamic learning of hostnames from routers in the domain and allows the routers to advertise the hostname in LSPs.

C9000 Series

Syntax

hostname dynamic

To disable this command, use the no hostname dynamic command.

Defaults Enabled.