Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

831

832

833

834

835

836

837

838

839

840

• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet then the

slot/port information.

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then

the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/

port information.

• For a port channel interface, enter the keywords port-channel then a number.

Command Modes EXEC

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.7(0.1) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on S-Series and Z–Series.

Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results.

debug ip igmp snooping

Enable debugging of IGMP snooping packets on interfaces and groups.

C9000 Series

Syntax

debug ip igmp snooping [group address | interface]

• To disable debugging of IGMP snooping, use the no debug ip igmp snooping [group address |

interface] command.

• To disable all debugging, use the undebug all command.

Parameters

snooping Enter the keyword snooping to enable debugging of IGMP snooping.

group-address

(OPTIONAL) Enter the IP multicast group address in dotted decimal format.

interface

Enter the following keywords and slot/port or number information: