Administrator Guide

Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
clear ip fib linecard
Clear all FIB entries on a line card (use this command with caution; refer to Usage Information.)
C9000 Series
Syntax
clear ip fib linecard slot—id
Parameters
linecard slot-id Enter the slot ID of a line card. Valid slot IDs are from 0 to 2.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.19.0 Introduced on the S4820T.
Usage Information To clear Layer 3 CAM inconsistencies, use this command.
CAUTION: Executing this command causes traffic disruption.
Related
Commands
show ip fib linecard — shows FIB entries on a specified stack-unit.
clear ip route
Clear one or all routes in the routing table.
C9000 Series
Syntax
clear ip route {* | ip-address mask}
IPv4 Routing 855