Administrator Guide

Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For the Management interface, enter the keyword ManagementEthernet then the
slot/port information. The slot range is from 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 4096.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE then
the pe-id / stack-unit / port-idinformation.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
count value (OPTIONAL) Enter the keyword count then the count value. The range is from 1 to
65534.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series ExaScale (the prior limit was 2094).
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.3.1.0 Added the count option.
Usage Information To stop packets from flooding the user terminal when debugging is turned on, use the count option.
debug ip dhcp
Enable debug information for dynamic host configuration protocol (DHCP) relay transactions and display the information on the console.
C9000 Series
Syntax
debug ip dhcp
To disable debug, use the no debug ip dhcp command.
Defaults Debug disabled
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
858 IPv4 Routing