Administrator Guide

Related
Commands
ipv6 name-server — configures an IPv6 name server.
ip proxy-arp
Enable proxy ARP on an interface.
C9000 Series
Syntax
ip proxy-arp
To disable proxy ARP, use the no ip proxy-arp command.
Defaults Enabled.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Related
Commands
show ip interface — displays the interface routing status and configuration.
ip route
Assign a static route to the switch.
C9000 Series
Syntax
ip route {destination mask {ip-address | interface [slot/port] | [tunnel
tunnel-id] [distance] | [permanent] | tag tag-value}}[vrf vrf-name ]
To delete a specific static route, use the no ip route destination mask command.
To delete all routes matching a certain route, use the no ip route destination mask command.
Parameters
destination Enter the IP address in dotted decimal format of the destination device.
mask Enter the mask in the slash prefix format (/x) of the destination IP address.
ip-address Enter the IP address of the forwarding router in dotted decimal format.
interface interface Enter one of the following keywords and slot/port or number information:
872 IPv4 Routing