Administrator Guide

management route
Configure a static route that points to the Management interface or a forwarding router.
C9000 Series
Syntax
management route {{ip-address mask | {ipv6-address prefix-length}} {forwarding-
router-address | managementethernet | fortyGigE | vlan | gigabitethernet |
tengigabitethernet}}
To remove a static route, use the no management route{{ip-address mask | {ipv6-address
prefix-length}}{forwarding-router-address | managementethernet | fortyGigE |
vlan | gigabitethernet | tengigabitethernet}} command.
Parameters
ip-address mask Enter an IP address (dotted decimal format) and mask (/prefix format) of the destination
subnet.
ipv6-address
prefix-length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix format) of the destination
subnet. Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in
the /x format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
forwarding-
router-address
Enter an IP address (dotted decimal format) or an IPv6 address (x:x:x:x::x format) of a
forwarding router.
managementether
net
Enter the keyword managementethernet for the Management interface on the
Primary RPM.
fortyGigE Enter the keyword fortyGigE to specify a forty Gigbit Ethernet interface.
vlan Enter the keyword vlan to specify a vlan interface.
gigbitethernet Enter the keyword gigabitethernet to specify a one Gigabit Ethernet interface.
tengigabitetherne
t
Enter the keyword tengigabitethernet to specify a ten Gigabit Ethernete interface.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.1) Introduced on the S3048-ON.
9.7(0.1) Introduced on the S4048-ON.
9.7(0.0) Added support for forty gigabit, vlan, and tengigabit ethernet interfaces. Introduced on
the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000 and added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the S4810.
878 IPv4 Routing