Administrator Guide

• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a tunnel interface, enter the keyword tunnel then the tunnel interface number.
The range is from 1 to 16383.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
linecard slot-id Enter the linecard slot-id parameters to specify the switch ports on a line card.
The range of slot IDs is from 0 to 2.
brief (OPTIONAL) Enter the keyword brief to view a brief summary of the interfaces and
whether an IP address is assigned.
configured (OPTIONAL) Enter the keyword configured to display the physical interfaces with
non-default configurations only.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(0.0) Updated the command output to include the unicast reverse path forwarding (uRPF)
status.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.1.1.2 Supported on the E-Series ExaScale E600i.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip interface command shown in the following example.
Lines Description
TenGigabitEthern
et 0/0...
Displays the interface’s type, slot/port, and physical and line protocol status.
Internet address... States whether an IP address is assigned to the interface. If an IP address is assigned,
that address is displayed.
IP MTU is... Displays IP MTU value.
Inbound access... Displays the name of the configured incoming access list. If none is configured, the phrase
“not set” is displayed.
Proxy ARP... States whether proxy ARP is enabled on the interface.
IPv4 Routing 887