Administrator Guide

[tengigabitethernet slot | slot/port] [fortyGigE slot | slot/port] [tunnel
tunnel-id] [vlan vlan-id]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a Loopback interface, enter the keyword Loopback then a number from 0 to
16383.
• For the Null interface, enter the keyword null then zero (0).
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a tunnel interface, enter the keyword tunnel then the tunnel ID.
• For a VLAN interface, enter the keyword VLAN.
• For a port channel interface, enter the keywords port-channel.
linecard slot-id Enter the linecard slot-id parameters to specify the switch ports on a line card.
The range of slot IDs is from 0 to 2.
brief (OPTIONAL) View a summary of IPv6 interfaces.
configured (OPTIONAL) View information on all IPv6 configured interfaces.
managementether
net slot/ port
(OPTIONAL) View information on an IPv6 Management port. Enter the slot number (0-1)
and port number zero (0).
loopback (OPTIONAL) View information for IPv6 Loopback interfaces.
port-channel (OPTIONAL) View information for IPv6 port channels.
tengigabitetherne
t
(OPTIONAL) View information for an IPv6 tengigabitethernet interface.
fortyGigE (OPTIONAL) View information for an IPv6 fortygigabitethernet interface.
tunnel tunnel-id (OPTIONAL) View information for a tunnel interface.
vlan (OPTIONAL) View information for IPv6 VLANs.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(0.0) Updated the command output to include the unicast reverse path forwarding (uRPF)
status.
9.9(0.0) Introduced on the C9010.
9.5(0.1) Added support for IPv6 recursive DNS addresses.
9.2(1.0) Introduced on the Z9500.
9.2.(0.0) Added support for tunnel interface.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.4.2.1 Introduced on the S-Series.
940 IPv6 Basics