Administrator Guide

iscsi profile-compellant
Configure the auto-detection of Dell Compellent arrays on a port.
C9000 Series
Syntax
iscsi profile-compellent
Defaults Dell Compellent disk arrays are not detected.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.6.(0.0) Introduced on the Z9500.
iscsi target port
Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication is monitored.
C9000 Series
Syntax
iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-address]
To remove the configured iSCSI target ports or IP addresses, use the no iscsi target port command.
Parameters
tcp-
port-2...tcpport-
16
Enter the tcp-port number of the iSCSI target ports. The tcp-port-n is the TCP port
number or a list of TCP port numbers on which the iSCSI target listens to requests.
Separate port numbers with a comma. The default is 860, 3260.
ip-address
(Optional)
Enter the ip-address that the iSCSI monitors. The ip-address specifies the IP address of
the iSCSI target.
Defaults 860, 3260
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.6(0.0) Introduced on the Z9500.
Usage Information
You can configure up to 16 target TCP ports on the switch in one command or multiple commands.
When you use the no iscsi target port command and the TCP port you want to delete is one bound to a
specific IP address, the IP address value must be included in the command.
iSCSI Optimization 951