Administrator Guide

Version Description
7.5.1.0 Added support for the violate-action and detail options.
6.5.1.0 Added support for Port Channel.
Example
Dell#show mac learning-limit
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Te 1/0 10 0 0 0
Te 1/1 5 0 0 0
Dell#show mac learning-limit interface gigabitethernet 1/0
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Te 1/0 10 0 0 0
Virtual LAN (VLAN) Commands
The following commands configure and monitor virtual LANs (VLANs). VLANs are a virtual interface and use many of the same commands
as physical interfaces.
You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN routing. FTP, TFTP, ACLs and SNMP are not
supported on a VLAN.
Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the VRRP state of a VLAN interface may continually switch
between Master and Backup.
NOTE:
For more information, refer to VLAN Stacking and VLAN-related commands, such as portmode hybrid in the
Interfaces chapter.
default vlan-id
Specify a VLAN as the Default VLAN.
C9000 Series
Syntax
default vlan-id vlan-id
To remove the default VLAN status from a VLAN and VLAN 1 does not exist, use the no default vlan-id
vlan-id syntax.
Parameters
vlan-id Enter the VLAN ID number of the VLAN to become the new Default VLAN. The range is
from 1 to 4094. The default is 1.
Defaults The Default VLAN is VLAN 1.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
Layer 2 969