Administrator Guide

Processor : RP
---------------
Received 100% traffic on fortyGigE 2/12 Total packets:168
LLC:0, SNAP:0, IP:165, ARP:0, other:3
Unicast:42, Multicast:126, Broadcast:0
Related
Commands
debug cpu-traffic-stats — enables CPU traffic statistics for debugging.
show cpu-interface-stats
View CPU interface statistics.
C9000 Series
Syntax
show cpu-interface-stats [cp | rp | linecard {slot-id} |all]
Parameters
cp Enter the keyword cp to display the interface statistics only from the Control Processor.
rp Enter the keyword rp to display the interface statistics only from the Route Processor.
linecard slot-id Enter the linecard slot-id parameters to display the interface statistics only from a
specified line card. The range of line-card slot IDs is from 0 to 11.
all Enter the keyword all to display the interface statistics from all switch CPUs, including
the Control Processor, Route Processor, and line cards.
Defaults Display interface statistics from all switch CPUs.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series
6.2.1.1 Introduced on the E-Series.
Usage Information Traffic statistics are sorted on a per-interface basis; the interface receiving the most traffic is displayed first. All
CPU and port information is displayed unless a specific port or CPU is specified. Traffic information is displayed for
router ports only; not for management interfaces.
Example
Dell#show cpu-traffic-stats cp
-- Partybus ethernet statistics --
Link state : Up
Recv Interrupts/Polls: 0
Recv Packets : 2027080 Transmit Packets : 590000
Recv Desc Error : 0 Transmit Desc Error : 0
Recv Out of Mem : 0 Transmit Out of Mem : 0
Recv Upper Layer Full: 0 Transmit Pause Pkts : 0
Recv Other Error : 0 Transmit Other Error: 0
Recv Restarts : 0
Control and Monitoring 99