Users Guide

interface peGigE pe-id/pe-stack—unit-id/port-number
• pe-id is a port-extender ID number from 0 to 255.
• pe-stack-unit-id is a PE stack-unit number from 0 to 7
• port-number is a port number from 1 to 48.
interface peTenGigE pe-id/unit-number/port-id
• pe-id is a port-extender ID number from 0 to 255.
• unit-number is a PE stack-unit number from 0 to 7
• port-id is from 25 to 28 or 49 to 52 depending on the PE.
NOTE: PE conguration commands are only available after you enable the extended-bridge feature. See Enabling the Port
Extender Feature.
NOTE: To locate a C1048P, enter the location-led pe pe-id stack-unit unit-number command in EXEC Privilege
mode to toggle the location LED for the PE on and o.
Interface Types
The following table describes dierent interface types.
Table 36. Types of Interfaces
Interface Type Modes Possible Default Mode Requires Creation Default State
Physical L2, L3
NOTE: For the
port extender
interface only L2
is supported.
Unset No Shutdown (disabled)
Management N/A N/A No No Shutdown (enabled)
Loopback L3 L3 Yes No Shutdown (enabled)
Null N/A N/A No Enabled
Port Channel L2, L3 L3 Yes Shutdown (disabled)
VLAN
NOTE: The VLAN
range is 1 – 4094.
VLAN 4092 and
VLAN 4093 are
reserved VLANs.
You cannot
congure these
VLANs.
L2, L3 L2 Yes (except default)
L2 - Shutdown (disabled)
L3 - No Shutdown
(enabled)
View Basic Interface Information
To view basic interface information, use the following command.
You have several options for viewing interface status and conguration parameters.
• Lists all congurable interfaces on the chassis.
EXEC mode
434
Interfaces