Administrator Guide

Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure this
setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default
VRF.
group-address
[ source-address ]
Enter the multicast group address and source address (if desired), in dotted decimal
format, to clear information on a specific group.
* Enter * to clear all multicast routes.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.11.3.0 Introduced on the C9000, S3048–ON, S3100, S4048–ON, S4048T-ON, S6000–ON,
S6010–ON, S6100–ON and Z9100–ON.
Related
Commands
• show ip pim tib — show the PIM tree information base.
ipv6 multicast-routing
Enables IPv6 multicast forwarding.
Syntax
ipv6 multicast-routing [vrf vrf-name]
To disable multicast forwarding, use the no ipv6 multicast-routing [vrf vrf-name] command.
Defaults Disabled.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to enable IP
multicast forwarding on that VRF.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
9.11.3.0 Introduced on the C9000, S3048–ON, S3100, S4048–ON, S4048T-ON, S6000–ON,
S6010–ON, S6100–ON and Z9100–ON.
Usage Information
After you enable multicast, you can enable IGMP and PIM on an interface. In INTERFACE mode, enter the ip
pim sparse-mode command to enable IGMP and PIM on the interface.
Related
Commands
• ip pim sparse-mode — enable IGMP and PIM on an interface.
show ipv6 mroute
View the IPv6 multicast routing table.
Syntax
show ipv6 mroute [vrf vrf-name] [static | group-address [source-address] |
count] | summary | vlt [group-address [source-address] | count]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure this
setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default
VRF.
static (OPTIONAL) Enter the keyword static to view static multicast routes.
Multicast 1039