Administrator Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
7.5.1.0 Added option for SA upper limit and the description option.
6.2.1.1 Introduced
Usage Information
The connect-source option is used to supply a source IP address for the TCP connection. When an interface
is specified using the connect-source option, the primary configured address on the interface is used.
If the total number of SA messages received from the peer is already larger than the limit when this command is
applied, those SA messages continue to be accepted. To enforce the limit in such situation, use the clear ip
msdp peer command to reset the peer.
Related
Commands
ip msdp sa-limit — configures the MSDP SA Limit.
clear ip msdp peer — clears the MSDP peer.
show ip msdp — displays the MSDP information.
ip msdp redistribute
Filter local PIM SA entries in the SA cache. SAs which the ACL denies time out and are not refreshed. Until they time out, they continue to
reside in the MSDP SA cache.
C9000 Series
Syntax
ip msdp redistribute [list acl-name]
Parameters
list acl-name lEnter the name of an extended ACL that contains permitted SAs. If you do not use this
option, all local entries are blocked.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced
Usage Information
Modifications to the ACL do not have an immediate effect on the sa-cache.
To apply the redistribute filter to entries already present in the SA cache, use the clear ip msdp sa-cache
local command.
Multicast Source Discovery Protocol (MSDP) 1059