Administrator Guide

ip pim dr-priority
Change the designated router (DR) priority for the interface.
C9000 Series
Syntax
ip pim dr-priority priority-value
To remove the DR priority value assigned, use the no ip pim dr-priority command.
Parameters
priority-value Enter a number. Preference is given to larger/higher number. The range is from 0 to
4294967294. The default is 1.
Defaults 1
Command Modes
INTERFACE
INTERFACE (BATCH Mode)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series on port-channels and the S-Series.
Usage Information The router with the largest value assigned to an interface becomes the designated router. If two interfaces
contain the same designated router priority value, the interface with the largest interface IP address becomes the
designated router.
ip pim neighbor-filter
To prevent a router from participating in protocol independent multicast (PIM), configure this feature.
C9000 Series
Syntax
ip pim neighbor-filter {access-list}
To remove the restriction, use the no ip pim neighbor-filter {access-list} command.
Parameters
access-list Enter the name of a standard access list. Maximum 16 characters.
Defaults none
Command Modes CONFIGURATION
PIM-Source Specific Mode (PIM-SSM) 1241