Administrator Guide

Address Prio/Mode↵
127.87.3.4 Te 1/16 09:44:58/00:01:24 v2 1 / S↵
show ip pim tib
View the PIM tree information base (TIB).
C9000 Series
Syntax
show ip pim tib [group-address [source-address]]
Parameters
group-address (OPTIONAL) Enter the group address in dotted decimal format (A.B.C.D).
source-address (OPTIONAL) Enter the source address in dotted decimal format (A.B.C.D).
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
Usage Information The following describes the show ip pim tib command shown in the following example.
Field Description
(S, G) Displays the entry in the multicast PIM database.
uptime Displays the amount of time the entry has been in the PIM route table.
expires Displays the amount of time until the entry expires and is removed from the database.
RP Displays the IP address of the RP/source for this entry.
flags List the flags to define the entries:
• D = PIM Dense Mode
• S = PIM Sparse Mode
• C = directly connected
• L = local to the multicast group
• P = route was pruned
• R = the forwarding entry is pointing toward the RP
• F = Dell Networking OS is registering this entry for a multicast source
• T = packets were received via Shortest Tree Path
• J = first packet from the last hop router is received and the entry is ready to switch to
SPT
• K = acknowledge pending state
PIM-Source Specific Mode (PIM-SSM) 1245