Administrator Guide

• For a port channel interface, enter the keyword port-channel and a the port-
channel ID.
• For a remote VLAN interface, enter the keyword Remote-VLAN and a vlan-id
number. Range is from 1 to 4094
interface Enter the one of the following keywords and slot/port information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
•
For a VLAN interface, enter the keyword VLAN and a vlan-id number. Range is from 1
to 4094.
• For a port channel interface, enter the keyword port-channel amd a the port-
channel ID.
direction {rx | tx |
both}
Enter the keyword direction then one of the packet directional indicators.
• rx: to monitor receiving packets only.
• tx: to monitor transmitting packets only.
• both: to monitor both transmitting and receiving packets.
Defaults none
Command Modes MONITOR SESSION (conf-mon- sess-session-ID)
Command History
This guide is platform-specific. For command information about other platforms, see to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.4.0.0 Added support for Source and destination.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information
You can configure a port extender (PE) Gigabit Ethernet peGigE port as a source port in the source (port
monitoring) command and monitor traffic flow on this port. You cannot configure a cascade port as a
destination port.
Example
Dell# monitor session 0
source Port-channel 10 destination TenGigabitEthernet 0/33 direction tx
1340 Port Monitoring