Administrator Guide

qos dscp-color-map
Configure the DSCP color map.
C9000 Series
Syntax
qos dscp-color-map map-name
To remove a color map, use the no qos dscp-color-map map-name command.
Parameters
map-name Enter the name of the DSCP color map. The map name can have a maximum of 32
characters.
Defaults None
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Usage Information
A color map outlines the codepoint mappings to the appropriate color mapping (green, yellow, red) for the traffic.
The system uses this information use to handle the traffic on the interface based on the traffic priority and places
it into the appropriate shaping queue. You cannot delete a DSCP color map when it is configured on an interface.
If you do, all the DSCP values are set to green (low drop precedence). To delete the DSCP color map that is being
used by one or more interfaces, remove the DSCP map from each interface.
Use this command in Configuration Terminal Batch mode to configure the DSCP color map in a dual-homing
setup.
Example
Dell(conf)#qos dscp-color-map mymap
Related
Commands
qos dscp-color-map— associates the DSCP color map profile with an interface so that all IP packets received on
it is given a color based on that color map
dscp— sets the number of specific DSCP values for color map profile to yellow or red.
qos dscp-color-policy
Associates the DSCP color map profile with an interface so that all IP packets received on it is given a color based on that color map.
C9000 Series
Syntax
dscp-color-policy color-map-profile-name
To remove a color policy map profile, use the no dscp-color-policy color-map-profile-name
command.
Parameters
color-map-profile-
name
Enter the color map profile name. The name can have a maximum of 32 characters.
Defaults None
1394 Quality of Service (QoS)