Administrator Guide
To turn off debugging output, use the no debug ip rip command.
Parameters
interface
(OPTIONAL) Enter the interface type and ID as one of the following:
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
database (OPTIONAL) Enter the keyword database to display messages when there is a change
to the RIP database.
events (OPTIONAL) Enter the keyword events to debug only RIP protocol changes.
packet (OPTIONAL) Enter the keyword packet to debug only RIP protocol packet.
trigger (OPTIONAL) Enter the keyword trigger to debug only RIP trigger extensions.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
default-information originate
Generate a default route for the RIP traffic.
C9000 Series
Syntax
default-information originate [always] [metric metric-value] [route-map map-
name]
To return to the default values, use the no default-information originate command.
Parameters
always (OPTIONAL) Enter the keyword always to enable the switch software to always
advertise the default route.
metric
metric-
value
(OPTIONAL) Enter the keyword metric then a number as the metric value. The range is
from 1 to 16. The default is 1.
1422 Routing Information Protocol (RIP)