Administrator Guide
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information Syslog messages contain the IP address of the interface used to egress the router. By configuring the logging
source-interface command, the Syslog packets contain the IP address of the interface configured.
Related
Commands
logging — enables logging to the Syslog server.
logging synchronous
Synchronize unsolicited messages and output.
C9000 Series
Syntax
logging synchronous [level level | all] [limit number-of-buffers]
To disable message synchronization, use the no logging synchronous [level level | all]
[limit number-of-buffers] command.
Parameters
all Enter the keyword all to ensure that all levels are printed asynchronously.
level
level
Enter the keyword level then a number as the severity level. A high number indicates a
low severity level and vice versa. The range is from 0 to 7. The default is 2.
all Enter the keyword all to turn off all.
limit
number-of-
buffers
Enter the keyword limit then the number of buffers to be queued for the terminal after
which new messages are dropped. The range is from 20 to 300. The default is 20.
Defaults Disabled. If enabled without the level or number-of-buffers options specified, level = 2 and number-of-
buffers = 20 are the defaults.
Command Modes LINE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Simple Network Management Protocol (SNMP) and Syslog 1577