Administrator Guide

Console logging: level debugging
Monitor logging: level debugging
Buffer logging: level debugging, 33 Messages Logged, Size (40960 bytes)
Trap logging: level informational
Jul 7 14:20:19: %PE1-UNIT1-M:CP %SEC-5-LOGIN_SUCCESS: Login successful on
console
show logging auditlog
Displays an audit log.
C9000 Series
Syntax
show logging auditlog
Defaults none
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Example
Dell(conf)#show logging audit
Related
Commands
clear logging auditlog — clears audit log.
show logging driverlog
Display the driver log for the specified hardware component.
C9000 Series
Syntax
show logging driverlog {cp | linecard slot-id | pe pe-id stack—unit unit number
From a PE console, use the show logging driverlog stack—unit unit number to view the driver
logging information for a specified stack-unit.
Parameters
cp Enter the keyword cp to display the driver log for the Control Processor on the switch.
linecard slot-id Enter the linecard slot-id parameters to specify the line-card ports for which you
want to display the driver log. The range of line-card slot IDs is from 0 to 11.
pe pe-id Enter the keyword pe and the port extender ID to display the driver log information for
the specified port extender. Port extender ID range is from 0 to 255.
stack unit-number Enter the keyword stack-unit and the unit number to display the driver log
information for the specified stack-unit. Stack unit range is from 0 to 7.
defaults none
Command Modes
• EXEC
• EXEC Privilege
Simple Network Management Protocol (SNMP) and Syslog 1583