Administrator Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
disable
Disable a VRRP group.
C9000 Series
Syntax
disable
To re-enable a disabled VRRP group, use the no disable command.
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information To enable VRRP traffic, assign an IP address to the VRRP group using the virtual-address command and
enter no disable.
Related
Commands
virtual-address — specifies the IP address of the virtual router.
hold-time
Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the initialization of the VRRP MASTER, the
new switch can stabilize its routing tables.
C9000 Series
Syntax
hold-time {seconds | centisecs centisecs}
To return to the default value, use the no hold-time command.
1694 Virtual Router Redundancy Protocol (VRRP)