Administrator Guide

To delete a filter, use the no seq sequence-number command.
Parameters
sequence-number Enter a number as the filter sequence number. The range is from zero (0) to 65535.
deny Enter the keyword deny to drop any traffic matching this filter.
permit Enter the keyword permit to forward any traffic matching this filter.
any Enter the keyword any to filter all packets.
host mac-address Enter the keyword host and then enter a MAC address to filter packets with that host
address.
mac-source-
address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
The MAC ACL supports an inverse mask; therefore, a mask of ff:ff:ff:ff:ff:ff allows entries
that do not match and a mask of 00:00:00:00:00:00 only allows entries that match
exactly.
mac-source-
address-mask
Specify which bits in the MAC address must be matched.
mac-destination-
address
Enter the destination MAC address and mask in nn:nn:nn:nn:nn:nn format.
mac-destination-
address-mask
Specify which bits in the MAC address must be matched.
The MAC ACL supports an inverse mask; therefore, a mask of ff:ff:ff:ff:ff:ff allows entries
that do not match and a mask of 00:00:00:00:00:00 only allows entries that match
exactly.
ethertype
operator
(OPTIONAL) To filter based on protocol type, enter one of the following Ethertypes:
• ev2 - is the Ethernet II frame format.
• llc - is the IEEE 802.3 frame format.
• snap - is the IEEE 802.3 SNAP frame format.
count (OPTIONAL) Enter the keyword count to count packets the filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the filter processes.
log (OPTIONAL) Enter the keyword log to include ACL messages in the log.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny commands. The threshold
range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which ACL logs must be generated. The threshold range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you
want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface. For more information, refer to the “Flow-based Monitoring” section
in the Port Monitoring chapter of the Dell Networking OS Configuration Guide.
Defaults Not configured.
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
268 Access Control Lists (ACL)