Administrator Guide

bgp log-neighbor-changes
Enable logging of BGP neighbor resets.
C9000 Series
Syntax
bgp log-neighbor-changes
To disable logging, use the no bgp log-neighbor-changes command.
Defaults Enabled.
Command Modes ROUTER BGP
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage Information The bgp log-neighbor-changes command appears in the show config command output.
Related
Commands
show config – views the current configuration.
bgp non-deterministic-med
Compare MEDs of paths from different autonomous systems.
C9000 Series
Syntax
bgp non-deterministic-med
To return to the default, use the no bgp non-deterministic-med command.
Defaults Disabled (that is, paths/routes for the same destination but from different ASs do not have their MEDs
compared).
Command Modes ROUTER BGP
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage Information
In non-deterministic mode, paths are compared in the order in which they arrive. This method can lead to the
system choosing different best paths from a set of paths, depending on the order in which they are received from
the neighbors because MED may or may not get compared between adjacent paths. In Deterministic mode (no
bgp non-deterministic-med), the system compares MED between adjacent paths within an AS group
because all paths in the AS group are from the same AS.
When you change the path selection from deterministic to non-deterministic, the path selection for existing paths
remains deterministic until you enter the
clear ip bgp command to clear existing paths.
Border Gateway Protocol 431